HP Deskjet 3636 cannot access Wi-Fi network when the user changes the wi-fi password Often, when a user modifies his or her Wi-Fi password, their HP Deskjet 3636 printer cannot enter the Wi-Fi network. HP Deskjet 3636 printer works reasonably well with USB and receives access to Wi-Fi until its user alters its password.
Step 1 : As a first step, they open the HP Deskjet 3636 software and configure the printer on wireless setup.
Step 2 : After choosing the SSID and supplying the password, they receive the following response: SSID cannot be found / FAIL.
Step 3 : Even after ensuring HP Deskjet 3636 printers face the forward part of the router; additional devices, however, receive access to the wi-fi network.
Step 4 : Even after configuring the printer with a different laptop.
Step 5 : After installing a firmware update and running this setup, the user can view his printer but not click it; what is more, it declares that the firmware status is unavailable.
Step 6 : Unsuccessful attempt with the print and doctor software.
Step 7 : Ineffective result with factory resetting of the user’s router.
Step 8 : Futile bid to press the Wi-Fi button and X button for three seconds till the Wi-Fi settings reset.
Step 9 : When the user connected HP Deskjet 3636 printer to a different Wi-Fi network and router, it displays ‘the SSID name is not found’ message.
Step 10 : Steps to help HP Deskjet 3636 access Wi-Fi network after the user changes the wi-fi password.
Step 2 : Install the printer with the USB cable and later, change the USB linked printer to Wireless to pick up the network.
Step 3 : For that, here are the steps:
The subsequent steps require the user to briefly sever connections with the network and Internet connections and restart their computers. To begin with, users must wrap up any tasks or downloads in progress before calling a halt.
Listed Below are Some Suggestions that can Help Users Resolve This Difficulty.
Step 2: Key in the IP address on your web browser to get the printer EWS page on your computer.
Step 3: Move to the "Network" tab.
Step 4: Under General, choose "Network protocols."
Step 5 : Opt for "Enable IPv4 only" (or similar).
Step 6 : Apply the settings.
Step 7 : Vist the “Network” tab.
Step 8 : Click “Wireless (802.11).”
Step 9 : Next, click “Network address (IPv4).”
Step 10: Thereafter, click on the “Manual IP” radio button.
Step 11 : Afterward, click “Suggest a manual IP address” to receive a manual IP address for your printer.
Step 12: After that, click the “Manual DNS Server” radio button. Under manual preferred, write 184.108.40.206 and under manual alternate, write 220.127.116.11 (This is the Google DNS server address)
Step 13: The moment, the process completes, reinstall the printer drivers.