How to Login to Samsung Printer SyncThru Web Service?

Please let me know that how to login to Samsung printer SyncThru web service. I am facing some issues while doing this. Help me.

  • Keith
  • 1 Answer
  • February 13, 2024
Answer - 1

Login to Samsung Printer SyncThru Web Service:

SyncThru web service is an internet-based software version created within network created Samsung printers. in order to use this service, you need to use a username and password. The default username is admin and the default password is sec00000. If you wish to learn how to login sync through web service,

Then follow the simple steps mentioned below. 

Step 1: Open your internet browser like Firefox or Chrome on your PC. Go to the URL section of the browser and then type the IP address. After that, press the enter key on your keyboard. Now, the synncThru Service window will open up. 

Step 2: You can also open the Syncthru web service by going to the Device Settings tab. 

Step 3: Now, go to the top-right side of the window and then click on login. 

Step 4: After that, the login page will open up. There, you will see two empty fields. One is the ID field and the other one is the password field. Enter admin in the ID field and sec00000 in the password field. After that, click on log in. 

Step 5: Now, you can change the password if you want. 

Step 6: Then, you will see some tabs at the top of the screen. A lot of options from there can be edited. If you wish to see printer information, then you can do that as well using Syncthru web service. Moreover, you can perform maintenance on your printer or change printer settings using this service. 

If You are Unable to Login, Then Follow the Steps Mentioned Below:

Step 1: Check that the default credentials are lower case. 

Step 2: In case you find that the ID or password was changed, then you must enter the updated ID and password

Step 3: In case the ID and password were changed and you aren't aware of it, then you must reset your network settings. This will bring your device back to default settings. 

  •   Steffan
  •   December 25, 2021